HP A6600 Configuration Manual page 371

Figure 101 Network diagram for IPv6 BIDIR-PIM configuration
Device
Router A
Router B
Router C
Procedure
Configure IPv6 forwarding, IPv6 addresses, and the IPv6 unicast routing protocol
1.
Enable IPv6 forwarding on each router, and configure the IPv6 address and prefix length for each
interface as per
Configure OSPFv3 on the routers in the IPv6 BIDIR-PIM domain to ensure network-layer reachability
among them. The configuration steps are omitted here.
Enable IPv6 multicast routing, IPv6 PIM-SM, IPv6 BIDIR-PIM, and MLD.
2.
# On Router A, enable IPv6 multicast routing, enable IPv6 PIM-SM on each interface, and enable IPv6
BIDIR-PIM.
<RouterA> system-view
[RouterA] multicast ipv6 routing-enable
[RouterA] interface GigabitEthernet 1/0/1
[RouterA-GigabitEthernet1/0/1] pim ipv6 sm
[RouterA-GigabitEthernet1/0/1] quit
[RouterA] interface Serial 2/0/1
[RouterA-Serial2/0/1] pim ipv6 sm
[RouterA-Serial2/0/1] quit
[RouterA] pim ipv6
Interface IPv6 address
GE1/0/1 1001::1/64
S2/0/1 1002::1/64
GE1/0/1 2001::1/64
S2/0/1 1002::2/64
S2/0/2 2002::1/64
S2/0/1 2002::2/64
S2/0/2 3001::1/64
Loop0 6001::1/128
Figure 101. The configuration steps are omitted here.
Device Interface
Router D GE1/0/1
GE1/0/2
S2/0/1
Source 1 -
Source 2 -
Receiver 1 -
Receiver 2 -
360
IPv6 address
4001::1/64
5001::1/64
3001::2/64
1001::2/64
5001::2/64
2001::2/64
4001::2/64