HP A6600 Configuration Manual page 76

Figure 25 IGMP queries and reports
Router A
Ethernet
Host A
(G2)
Query
Report
Assume that Host B and Host C will receive multicast data addressed to multicast group G1, and Host A
will receive multicast data addressed to G2, as shown in
the hosts join the multicast groups and how the IGMP querier (Router B in the figure) maintains the
multicast group memberships:
The hosts send unsolicited IGMP reports to the addresses of the multicast groups that they want to
1.
join, without having to wait for the IGMP queries from the IGMP querier.
The IGMP querier periodically multicasts IGMP queries (with the destination address of 224.0.0.1)
2.
to all hosts and routers on the local subnet.
After receiving a query message, Host B or Host C (the delay timer of whichever expires first) sends
3.
an IGMP report to the multicast group address of G1, to announce its membership for G1. Assume
that Host B sends the report message. After receiving the report from Host B, Host C—which is on
the same subnet as Host B—suppresses its own report for G1, because the IGMP routers (Router A
and Router B) have already known that at least one host on the local subnet is interested in G1. This
mechanism—known as "IGMP report suppression"—helps reduce traffic on the local subnet.
At the same time, because Host A is interested in G2, it sends a report to the multicast group
4.
address of G2.
Through the query/report process, the IGMP routers determine that members of G1 and G2 are
5.
attached to the local subnet, and the multicast routing protocol (PIM, for example) that is running on
the routers generates (*, G1) and (*, G2) multicast forwarding entries. These entries will be the
basis for subsequent multicast forwarding, where asterisk represents any multicast source.
When the multicast data addressed to G1 or G2 reaches an IGMP router, because the (*, G1) and
6.
(*, G2) multicast forwarding entries exist on the IGMP router, the router forwards the multicast data
to the local subnet, and then the receivers on the subnet receive the data.
IGMPv1 does not specifically define a leave group message—often called a "leave message". When an
IGMPv1 host is leaving a multicast group, it stops sending reports to the address of the multicast group
that it listened to. If no member exists in a multicast group on the subnet, the IGMP router will not receive
any report addressed to that multicast group. In this case, the router will delete the multicast forwarding
entries for that multicast group after a period of time.
IP network
DR
Router B
Host B
(G1)
65
Host C
(G1)
Figure 25. The following process describes how