HP A6600 Configuration Manual page 377

Ip multicast
Hide thumbs Also See for A6600:
Table of Contents

Advertisement

[RouterA-GigabitEthernet1/0/1] mld version 2
[RouterA-GigabitEthernet1/0/1] pim ipv6 sm
[RouterA-GigabitEthernet1/0/1] quit
[RouterA] interface Serial 2/0/0
[RouterA-Serial2/0/0] pim ipv6 sm
[RouterA-Serial2/0/0] quit
[RouterA] interface pos 5/0/0
[RouterA-Pos5/0/0] pim ipv6 sm
[RouterA-Pos5/0/0] quit
The configuration on Router B and Router C is similar to that on Router A. The configuration on Router D
and Router E is also similar to that on Router A except that it is not necessary to enable MLD on the
corresponding interfaces on these two routers.
Configure the IPv6 SSM group range
3.
# Configure the IPv6 SSM group range to be FF3E::/64 on Router A.
[RouterA] acl ipv6 number 2000
[RouterA-acl6-basic-2000] rule permit source ff3e:: 64
[RouterA-acl6-basic-2000] quit
[RouterA] pim ipv6
[RouterA-pim6] ssm-policy 2000
[RouterA-pim6] quit
The configuration on Router B, Router C, Router D and Router E is similar to that on Router A.
Verify the configuration
4.
Use display pim ipv6 interface to view the IPv6 PIM configuration and running status on each interface.
For example:
# Verify the IPv6 PIM configuration information on Router A.
[RouterA] display pim ipv6 interface
Interface
GE1/0/1
Ser2/0/0
Pos5/0/0
Assume that Host A needs to receive the information a specific IPv6 multicast source S (4001::100/64)
sends to multicast group G (FF3E::101). Router A builds an SPT toward the multicast source. Routers on
the SPT path (Router A and Router D) have generated an (S, G) entry, but Router E, which is not on the
SPT path, does not have multicast routing entries. You can use display pim ipv6 routing-table to view the
PIM routing table information on each router. For example:
# View the IPv6 PIM multicast routing table information on Router A.
[RouterA] display pim ipv6 routing-table
Total 0 (*, G) entry; 1 (S, G) entry
(4001::100, FF3E::101)
Protocol: pim-ssm, Flag:
UpTime: 00:00:11
Upstream interface: Serial2/0/0
Upstream neighbor: 1002::2
NbrCnt HelloInt
DR-Pri
0
30
1
1
30
1
30
366
DR-Address
1001::1
(local)
1
1002::2
1
1003::2

Advertisement

Table of Contents
loading

Table of Contents