HP A6600 Configuration Manual page 200

Figure 57 Network diagram for SA message filtering configuration
PIM-SM 1
Receiver
Host A
Source 1
Device
Source 1
Source 2
Router A
Router B
Procedure
Configure IP addresses and unicast routing
1.
Configure the IP address and subnet mask for each interface as per
steps are omitted here.
Configure OSPF for interoperation among the routers. Ensure the network-layer interoperation within and
between the PIM-SM domains and ensure dynamic update of routing information among the routers by
leveraging unicast routing. The detailed configuration steps are omitted here.
Enable IP multicast routing, PIM-SM and IGMP, and configure a PIM domain border
2.
# On Router A, enable IP multicast routing, enable PIM-SM on each interface, and enable IGMP on the
host-side interface, GigabitEthernet 0/0/1.
<RouterA> system-view
[RouterA] multicast routing-enable
[RouterA] interface GigabitEthernet 0/0/0
[RouterA-GigabitEthernet0/0/0] igmp enable
[RouterA-GigabitEthernet0/0/0] pim sm
Loop0
GE0/0/0
Router A
GE0/0/3
GE0/0/3
GE0/0/0
Router B
MSDP peers
Interface IP address
— 10.110.3.100/24
— 10.110.6.100/24
GE0/0/0 10.110.1.1/24
GE0/0/3 10.110.2.1/24
GE0/0/1 192.168.1.1/24
Loop0 1.1.1.1/32
GE0/0/0 10.110.3.1/24
GE0/0/3 10.110.2.2/24
GE0/0/1 192.168.2.1/24
PIM-SM 2
Loop0
Router C
GE0/0/3
GE0/0/0
Receiver
Host B
Device
Router C
Router D
189
PIM-SM 3
Source 2
GE0/0/0
GE0/0/3
Router D
GE0/0/2
Receiver
Host C
Interface IP address
GE0/0/0 10.110.4.1/24
GE0/0/3 10.110.5.1/24
GE0/0/1 192.168.1.2/24
GE0/0/2 192.168.2.2/24
Loop0 2.2.2.2/32
GE0/0/0 10.110.6.1/24
GE0/0/1 10.110.7.1/24
GE0/0/3 10.110.5.2/24
Loop0 3.3.3.3/32
Figure 57. The detailed configuration