Configuring Join/Prune Message Sizes - HP A6600 Configuration Manual

To do...
4. Configure the join/prune
interval.
5. Configure the join/prune
timeout time.
6. Configure assert timeout time.
7. Configure the multicast source
lifetime.
Configuring PIM common timers on an interface
If there are no special networking requirements, use the default settings.
To do...
1. Enter system view.
2. Enter interface view.
3. Configure the hello interval.
4. Configure the maximum delay
between hello messages.
5. Configure the join/prune
interval.
6. Configure the join/prune
timeout time.
7. Configure assert timeout time.

Configuring join/prune message sizes

A larger join/prune message size will result in loss of a larger amount of information if a message is lost;
with a reduced join/message size, the loss of a single message brings relatively minor impact.
By controlling the maximum number of (S, G) entries in a join/prune message, you can effectively reduce
the number of (S, G) entries sent per unit of time.
To do...
1. Enter system view.
2. Enter public network PIM view
or VPN instance PIM view.
3. Configure the maximum size
of a join/prune message.
Use the command...
timer join-prune interval
holdtime join-prune interval
holdtime assert interval
source-lifetime interval
Use the command...
system-view
interface interface-type
interface-number
pim timer hello interval
pim triggered-hello-delay interval
pim timer join-prune interval
pim holdtime join-prune interval
pim holdtime assert interval
Use the command...
system-view
pim [ vpn-instance
vpn-instance-name ]
jp-pkt-size packet-size
134
Remarks
Optional.
60 seconds by default.
Optional.
210 seconds by default.
Optional.
180 seconds by default.
Optional.
210 seconds by default.
Remarks
—
—
Optional.
30 seconds by default.
Optional.
5 seconds by default.
Optional.
60 seconds by default.
Optional.
210 seconds by default.
Optional.
180 seconds by default.
Remarks
—
—
Optional.
8,100 bytes by default.