Neighbor Discovery; Spt Building - HP A6600 Configuration Manual

Neighbor discovery

In a PIM domain, a PIM router discovers PIM neighbors, maintains PIM neighboring relationships with
other routers, and builds and maintains SPTs by periodically multicasting hello messages to all other PIM
routers (224.0.0.13) on the local subnet.
Every PIM-enabled interface on a router sends hello messages periodically and learns the PIM
neighboring information pertinent to the interface.

SPT building

The process of building an SPT is the flood-and-prune process.
In a PIM-DM domain, when a multicast source S sends multicast data to multicast group G, the
1.
multicast packet is first flooded throughout the domain. The router first performs RPF check on the
multicast packet. If the packet passes the RPF check, the router creates an (S, G) entry and forwards
the data to all downstream nodes in the network. In the flooding process, an (S, G) entry is created
on all the routers in the PIM-DM domain.
Then, nodes without receivers downstream are pruned. A router having no receivers downstream
2.
sends a prune message to the upstream node to "tell" the upstream node to delete the corresponding
interface from the outgoing interface list in the (S, G) entry and stop forwarding subsequent packets
addressed to that multicast group down to this node.
An (S, G) entry contains the multicast source address S, multicast group address G, outgoing interface list,
and incoming interface.
For a given multicast stream, the interface that receives the multicast stream is referred to as "upstream",
and the interfaces that forward the multicast stream are referred to as "downstream".
A prune process is first initiated by a leaf router. As shown in
attached to it (the router connected with Host A, for example) sends a prune message, and this prune
process goes on until only necessary branches are left in the PIM-DM domain. These branches constitute
the SPT.
Figure
92
32, a router without any receiver