HP A6600 Configuration Manual page 46

Figure 15 Network diagram for static port configuration
Source
1.1.1.2/24
1.1.1.1/24
Procedure
Configure IP addresses
1.
Configure an IP address and subnet mask for each interface as per
steps are omitted.
Configure Router A
2.
# Enable IP multicast routing, enable PIM-DM on each interface, and enable IGMP on Ethernet 1/1.
<RouterA> system-view
[RouterA] multicast routing-enable
[RouterA] interface ethernet 1/1
[RouterA-Ethernet1/1] igmp enable
[RouterA-Ethernet1/1] pim dm
[RouterA-Ethernet1/1] quit
[RouterA] interface ethernet 1/2
[RouterA-Ethernet1/2] pim dm
[RouterA-Ethernet1/2] quit
Configure Router B
3.
# Enable IGMP snooping globally.
<RouterB> system-view
[RouterB] igmp-snooping
[RouterB-igmp-snooping] quit
# Create VLAN 100, assign GigabitEthernet 1/0/1 through GigabitEthernet 1/0/3 to this VLAN, and
enable IGMP snooping in the VLAN.
[RouterB] vlan 100
[RouterB-vlan100] port GigabitEthernet 1/0/1 to GigabitEthernet 1/0/3
[RouterB-vlan100] igmp-snooping enable
[RouterB-vlan100] quit
Eth1/2 Eth1/1
10.1.1.1/24
Router A
IGMP querier
Router B
GE1/0/1
Host C
Receiver
VLAN 100
35
Router C
Router D
Host A
Receiver
Host B
Figure 15. The detailed configuration