Source Port - HP MSR1003-8S Command Reference Manual

Views
ICMP echo operation view
Predefined user roles
network-admin
Parameters
ipv6-address: Specifies the source IPv6 address for probe packets. IPv6 link-local addresses are not
supported.
Usage guidelines
If you configure both the source interface and source ipv6 commands for an ICMP echo operation, the
most recent configuration takes effect.
The specified source IPv6 address must be the IPv6 address of a local interface. The local interface must
be up. Otherwise, no probe packets can be sent out.
Examples
# Specify 1::1 as the source IPv6 address for ICMP echo requests.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] source ipv6 1::1
Related commands
source interface

source port

Use source port to configure the source port number for probe packets.
Use undo source port to remove the configured source port number.
Syntax
source port port-number
undo source port
Default
No source port number is configured for probe packets.
Views
SNMP/voice operation view
UDP echo operation view
UDP jitter operation view
UDP tracert operation view
Predefined user roles
network-admin
Parameters
port-number: Specifies the source port number in the range of 1 to 65535.
69