HP A6600 Configuration Manual page 395

Router A
Router B
Procedure
Configure IPv6 addresses for router interfaces as shown in
1.
are omitted here.
Configure OSPFv3. Detailed configuration steps are omitted here.
2.
Enable IPv6 multicast routing, IPv6 PIM-SM and MLD, and configure an IPv6 PIM-SM domain
3.
border.
# Enable IPv6 multicast routing on Router A, and enable PIM-SM on each interface.
<RouterA> system-view
[RouterA] multicast ipv6 routing-enable
[RouterA] interface gigabitGigabitEthernet 1/0/0/1
[RouterA-GigabitEthernet1/0/1] pim ipv6 sm
[RouterA-GigabitEthernet1/0/1] quit
[RouterA] interface pos 5/0/0
[RouterA-Pos5/0/0] pim ipv6 sm
[RouterA-Pos5/0/0] quit
The configuration on Router B and Router D is similar to the configuration on Router A.
# Enable IPv6 multicast routing on Router C, enable IPv6 PIM-SM on each interface, and enable MLD on
the host-side interface GigabitEthernet 1/0/1.
<RouterC> system-view
[RouterC] multicast ipv6 routing-enable
[RouterC] interface serial 2/0/0
[RouterC-Serial2/0/0] pim ipv6 sm
[RouterC-Serial2/0/0] quit
[RouterC] interface serial 2/0/1
[RouterC-Serial2/0/1] pim ipv6 sm
[RouterC-Serial2/0/1] quit
[RouterC] interface gigabitethernet 1/0/1
[RouterC-GigabitEthernet1/0/1] pim ipv6 sm
[RouterC-GigabitEthernet1/0/1] mld enable
[RouterC-GigabitEthernet1/0/1] quit
# Configure an IPv6 PIM domain border on Router A.
[RouterA] interface pos 5/0/0
[RouterA-Pos5/0/0] pim ipv6 bsr-boundary
[RouterA-Pos5/0/0] quit
# Configure an IPv6 PIM domain border on Router B.
[RouterB] interface pos 5/0/0
[RouterB-Pos5/0/0] pim ipv6 bsr-boundary
[RouterB-Pos5/0/0] quit
GE1/0/1 1002::1/64
POS5/0/0 1001::1/64
POS5/0/0 1001::2/64
S2/0/0 2001::1/64
S2/0/1 2002::1/64
S2/0/0
S2/0/1
Router D S2/0/0
S2/0/1
Figure
384
3001::1/64
2001::2/64
2002::2/64
3001::2/64
103. Detailed configuration steps