Program 16 Assign Exchange Line Groups (Or Dial 9); Program 16 Overview - Toshiba Strata DK40 Programming Manual

System & Station
Program 16
Assign Exchange Line Groups (or Dial 9)
Program Type:
Initialised Default:
(QWHU 3URJ 0RGH 0 6SNU
SELECT = Exchange Line Group (see legend)
Only enter the last two digits of the Exchange Line
Group, or enter 33 for Dial 9 group.
LED Number
12
11
10
09
08
07
06
05
04
03
02
01

Program 16 Overview

Use Program 16 to assign each Exchange line to an Exchange line group or a general "dial 9"
group. A general group for outside calling is available with a "dial 9" access code as the
initialised state for all lines.
Lines can be accessed with a dialling code instead of with a Exchange /LQH button. This is
used in Least Cost Routing and Pooled Line Button assignments.
Do not attempt to assign a line to more than one group. A line need not be assigned to a group
unless using LCR. If lines are not used, they should be taken out of all groups, including the
"dial 9" group. Automatic Busy Redial (ABR) will not function if unconnected (unused)
lines are assigned to a line group.
After programming, press:
3-38
System
All Exchange Lines assigned to the Dial 9 group
4 9 +ROG 0 6SNU
Processor Type
DK40
Line
801 802
012
011
010
009
008
007
006
005
004
003
002
001
9RO
to turn all LEDs ON
9RO
to turn all LEDs OFF
0RGH
and Exchange line number, then

Program 16 Assign Exchange Line Groups (or Dial 9)

+ROG 0 6SNU
LED Buttons = Exchange Line
Specify Exchange Line by setting LED's as defined by the table below.
When you are finished, all LED's with an "X" should be lit.
Exchange Line Exchange Line
Range
001~012
Exchange Line Groups
803 804 805
&
to display and advance
Strata DK40 Programming Manual Spring 1999
& & +ROG 0 6SNU
Groups
801~808
806 807 808
& & +ROG
Dial
9(00)