Program 91-1 Automatic Pcb Recognition And Port Renumber; Program 91-1 Overview - Toshiba Strata DK40 Programming Manual

Initialisation & Test
Program 91-1
Automatic PCB Recognition and Port Renumber
Program Type:
Initialised Default:
(QWHU 3URJ 0RGH

Program 91-1 Overview

Program 91-1 makes slot code assignments to installed PCBs that do not have options - such
as a PDKU without Off-hook Call Announce (OCA), the common control without a
Dual-tone Multi-frequency Receiver K5RCU etc.
Program 91-1 also sets physical and logical ports to their initialised settings - even if you
previously relocated them. (See Program 01 and 02 for initialised settings.). Programs 04, 05,
09, or 71 are not affected.
*
CAUTION!
Important!
Notes
2-6

Program 91-1 Automatic PCB Recognition and Port Renumber

Initialisation
None
0 6SNU < 4 +ROG
Enter programming mode.
(Do not press [DN] button.)
Running Program 91-1 drops all calls.
To identify Program 03 PCB slot codes, run Program 91-1 after you install all
PCBs.
You can run Program 91-1 after setting PCB option codes with Program 03;
this does not erase option codes. For example, if Slot 00 is assigned code 98,
Program 91-1 will not erase the codes previously assigned with Program 03.
If you install PCBs before initialising the system with Program 91-9, it is not
necessary to run Program 91-1 to assign the Program 03 PCB slot codes for
the installed PCBs. You must always run Program 03 to identify PCB options
such as K5RCU codes 98 and PDKU codes 62 and 64, etc.
0 6SNU 4 34 35 +ROG
Strata DK40 Programming Manual Spring 1999
0 Program Telephone Exits Program Mode
Press LED Buttons 01 and 02.
LEDs 01 and 02 must be ON.
LCD Displays: 91 SELECT = 1
Renumber and Reset