Program 50-1 Lcr Parameters - Toshiba Strata DK40 Programming Manual

Least Cost Routing
Program 50-1
LCR Parameters
Program Type:
Initialised Default:
(QWHU 3URJ 0RGH
LED X
05
04
03
02
01
Program 50-1 Overview
This program defines general operating parameters for LCR software.
LED 01: Enable System LCR
LED 01 ON: LCR software is enabled system-wide.
LED 01 OFF: LCR software is disabled. None of the LCR programming referred to by this
section is recognised. Dial 9 access assigned in Program 16 is enabled.
LED 02: LCR Speed Up
LED 02 ON: LCR Call Speed Up enabled system-wide.
LED 02 OFF: LCR Call Speed Up is disabled system-wide.
Note
LED 03: Not Used
5-6
Least Cost Routing
All LEDs OFF
0 6SNU 8 3 +ROG
SELECT = 1
LED ON
Warning Tone Last Choice Route Numbers
Dial Tone After LCR Access
Not Used
LCR Speed Up
Enable System LCR
Program 40 denies Exchange line access via LCR, but denies all other access
methods.
Program 41 allows Exchange line access via LCR, but denies all other outgoing
access methods: (#7001~#7012, 801~808, Line button).
Toll Restricted standard telephones should be forced to dial outgoing calls via LCR.
This is to prevent Toll Restriction defeat when the K5RCU times out.
If LCR Speed Up is enabled, the call will automatically follow the local Route Plan
08 and override any local Toll Restriction set. In addition the ABR feature will not
operate correctly.
0 6SNU 4 +ROG
Strata DK40 Programming Manual Spring 1999

Program 50-1 LCR Parameters

0 6SNU & & +ROG 0 6SNU &
Press LED Buttons for each LCR parameter
LED OFF
No Warning Tone
Silent
Not Used
Not Enabled
No LCR
& +ROG
LED
05
04
03
02
01