Program *60 Tbsu/Rbsu/Rbss Circuit Operation (Nt Or Te) - Toshiba Strata DK40 Programming Manual

System & Station
Program *60
TBSU/RBSU/RBSS Circuit Operation (NT or TE)
Program Type:
Initialised Default:
(QWHU 3URJ 0RGH 0 6SNU
Enter Slot Number
Key Line
1
2
3
4
Key Line
1
2
Program *60 Overview
This programming option is used to select NT or TE operation for each of the circuits on a
TBSU/RBSU unit.
Refer to the legend to which operation mode is available on each of the PCB's.
Program 61-1
Fault Test Report Destination
Program Type:
Initialised Default:
(QWHU 3URJ 0RGH 0 6SNU
Program 61-1 Overview
This program is for setting the destination for the results of the test when completed.
Option 0: The automatic fault testing will not be run.
Option 1: The system will carry out the test and wait for the information to be received via
the TTY or remotely through the IMDU Modem.
Option 2: The system will carry out the test and report to the SMDR.
3-112

Program *60 TBSU/RBSU/RBSS Circuit Operation (NT or TE)

System
RBSU = NT
9 3 +ROG 0 6SNU
*
RBSU/RBSS Cct Number
1
2
3
4
TBSU Cct Number
1
2
System
'0' No Check
9 4 +ROG 0 6SNU 4
/LQH .H\ 0 +ROG 0 6SNU
Press the Line Key to switch between TE and NT operation
LED ON
TE
TE
N/A
N/A
LED ON
TE
TE
+ROG 0 6SNU & & +ROG
DATA = 0 No check
1 Check and awaiting access via TTY or IMDU
2 Check and report to SMDR
Strata DK40 Programming Manual Spring 1999
6SNU & & +ROG 0 6SNU &
LED OFF
NT (Default)
NT (Default)
NT
NT
LED OFF
NT (Default)
NT (Default)
0 6SNU & & +ROG
& +ROG