Program 10-3 Overview; Led 19: Speed Dial Entry Timeout; Led 18: Built-In Auto Attendant Camp-On Busy/Ring No Answer Routing; Leds 16 And 17: Built-In Auto Attendant Disconnect Time - Toshiba Strata DK40 Programming Manual

System & Station

Program 10-3 Overview

You can make the following system assignments with Program 10-3:

LED 19: Speed Dial Entry Timeout

Station users can either have up to one minute or up to three minutes to store a Speed Dial
number or memo. If they do not store the number or memo within the set time, their station
exits the Speed Dial-storage mode and returns to the normal idle state. The timer is required
because of the User Programmable Feature Buttons feature, which allows the [PDN], +ROG,
and &QI27UQV buttons to be programmed in Speed Dial Memory. The three-minute setting
is recommended if station users frequently store memos with Speed Dial numbers using the
0RGH button below the LCD.
LED 18: Built-in Auto Attendant Camp-on Busy/Ring No
Answer Routing
This option is designed for Auto Attendant configurations that have primary announcement
devices, but no secondary ones, tells the system where to route Auto Attendant calls that ring
and are not answered or have been camped-on for a designated time
calls can be sent back to the primary announcement device or to the station or stations
assigned to the Exchange lines' normal ringing pattern

LEDs 16 and 17: Built-in Auto Attendant Disconnect Time

If LED 18 is assigned for normal ringing, set LEDs 16 and 17 to tell the system when to
disconnect Built-in Auto Attendant calls that have not been answered by the alternative
stations.
The time the Auto Attendant rings stations
caller does not dial and/or a ringing station does not answer. If a call is not answered before
ring disconnect time period time-out, the call will disconnect. This prevents loop start lines
from being locked-up when there is no CPC supervision from the local exchange after the
outside caller hangs up.
Set LEDs 16 and 17 for the desired time as follows:

LED 15: Built-in Auto Attendant MOH/RBT for Transfer

Callers can hear ring back tone (RBT) or Music-on-hold (MOH) after being transferred from
the Built-in Auto Attendant to a station, depending on the selection made with LED 15.
3-24
40 seconds: LED 16 OFF, LED 17 OFF (Initialised default)
120 seconds: LED 16 OFF, LED 17 ON
240 seconds: LED 16 ON, LED 17 OFF
Program 10-3 System Assignments, Part 3 of 5
(see Programs 81, 84, and
(per Program 81, 84,
Strata DK40 Programming Manual Spring 1999
(see Program 26). The
87).
87) after a loop start line