Program 90 Initialise Programs 00~*99; Program 90 Overview - Toshiba Strata DK40 Programming Manual

Initialisation & Test
Program 90
Initialise Programs 00~*99
Program Type:
Initialised Default:
(QWHU 3URJ 0RGH
Enter programming
mode.

Program 90 Overview

Program 90 enables you to clear all customer data and initialise individual programs or range
of programs.
Important!
Notes
2-4
Initialisation
See individual programs
0 6SNU < 3 +ROG 0 6SNU
Programs to be initialised.
Press LED Buttons 01 and 02.
LEDs 01 and 02 must be ON.
When installing the system, you must run Program 91-9 which runs Program
90 (before running any other program); if you do not, the system could begin
to operate erratically.
Running Program 91-9, automatically runs Program 90.
To initialise all programs without dropping calls or erasing user names, speed
dial numbers, voice mail ID codes, etc., enter 33
initialised."
Each "*" program record sheet immediately follows the program record sheet
having the same number (example: *31 follows 31 record sheet). However, in
system memory all "*" programs follow Program 99. Therefore, "
ranges must be initialised separately from non-star programs unless initialising
all system Programs (00**99).
For example, to initialise Programs 30, *30, 31, *31, and 32: initialise the range
(30*32), for Programs 30, 31, 32; and the range (*30**31), for Programs *30
and *31.
If you are installing the system for the first time, run Program 91-9 to erase
random data from RAM (caused by battery jumper movement to the internal
battery). You can then skip Program 90, since Program 91-9 automatically runs
Program 90.

Program 90 Initialise Programs 00~*99

& 34 35 +ROG 0 6SNU &
LEDs 01 and 02 must flash.
--
Strata DK40 Programming Manual Spring 1999
& +ROG 0 6SNU
End Program 90. Exit programming
mode.
<< as "Programs to be
" program
*
& & +ROG