Program 78 Overview - Toshiba Strata DK40 Programming Manual

Program 78 Exchange Line Special Ringing Assignments

Program 78 Overview

This program assigns loop start Exchange lines:
to ring over external page during night mode
to be used with DISA features
for direct access to IMDU modem
for Auto Attendant operation
Feature 1: Ring Over External Page During Night Mode
This program selects which ground/loop start Exchange lines will activate ringing over
external paging facilities during the NIGHT mode (for Tenants 1~4). The NT Relay on the
PIOU, PIOUS, or PEPU will also be activated if it is in the 1-second ON/3-seconds OFF
mode.
Feature 2: DISA Exchange Line Assignment
This program assigns loop start Exchange lines to be used with the Direct Inward System
Access (DISA) features. These lines may be set for DISA operation during the different
system modes of DAY, DAY2, and NIGHT. A line will switch to normal ringing after ten
seconds if the outside caller does not use the DISA feature. Normal function of these lines
occurs for outgoing calls.
Note
Feature 5: Ring IMDU Maintenance Modem
The IMDU Remote Maintenance modem can be directly accessed by incoming Exchange
lines assigned in this Program. Different alternatives are available for the system modes of
DAY, DAY2, and NIGHT. If none of these are selected, the IMDU can still be reached by
dialling a modem [DN] with the DISA feature or by a Ring Transfer from the DSS console
attendant or any other station. The IMDU modem must be enabled with Program 77-1, LED
14-ON. If Program *11 is used to assign a CPN to ring the IMDU, (RPTU, TBSU or RBSU
trunks only), ensure that the logical trunk number used in Program *11 is selected in Program
78.
Feature 6: Built-in Auto Attendant Exchange Line Assignment
This feature selects loop start Exchange lines for Auto Attendant operation. There is no limit
to the number of lines which can be assigned with Auto Attendant. Different alternatives are
available for system modes DAY, DAY2, and NIGHT.
Strata DK40 Programming Manual Spring 1999
An optional security code for DISA outgoing lines calls is available via Program
60-6. This code should always be programmed when using DISA and built-in Auto
Attendant to prevent unauthorised calls through the DK40 system.
System & Station
3-177