Program 03 For Dk40 - Overview - Toshiba Strata DK40 Programming Manual

System & Station

Program 03 for DK40 - Overview

Program 03 tells the system what type of optional PCBs are installed in the Expansion KSU.
You must run Program 03 after installing PCBs with options such as OCA, etc. Also, run
Program 03 for each PCB slot when installing a PCB in that location.
It is not necessary to run Program 03 for slots 00~14. The DK40 automatically assigns the
Base Key Service Unit (KSU) PCBs if they are installed when system power is turned ON.
However, if a DSS is required on the Base KSU's DKT circuit 8, you must run Program 03 to
assign code 64 to slot 11. If universal PCBs are installed, Program 91-1 and 91-9
automatically assigns the appropriate PCB codes to the installed slots. But, Programs 91-1 or
91-9 do not assign option codes (such as OCA, DIU, etc.).
Codes allowed in DK40 Base KSU: 11, 21, 23, 31, 61, 62, 64, 77, 91, and 98.
3-4
PCB Code Reference Table
PCB Fixed Slot
Common Control
Common Control with
K5RCU
PIOU/PIOUS/PEPU
PEKU
PEKU with DSS
KSTU3/RSTU2/
Stratagy DK
TCOU/PCOU
Base Unit DKT Ccts
and PDKU
Base Unit DKT Ccts
& PDKU w/ OCA
Base Unit DKT Ccts
and PDKU with DSS
(w/ or w/o OCA)
PACU
PEMU
PIOU/PIOUS + MIS
RPTU
TBSU/RBSU
RBSU + RBSS
None
Program 03 Flexible PCB Slot Assignments
Code Ports/Type
91 None
98 5 DTMF Receivers
41 Remote
Maintenance TTY
21 8 EKT
23 8 EKT
31 4 SLT/8 SLT/8VM
11 4/Exch. Lines
61 8 DKT
62 8 DKT
64 8 DKT
14 4AC15 Tie Lines
13 4DC5 Tie Lines
42 MIS for ACD (TTY)
76 ISDN30
(12 CHANNELS)
77 2CCT ISDN2 (TE
or NT)
78 2CCT ISDN2
(2CCT TE or NT +
2CCT NT ONLY)
00 None
Strata DK40 Programming Manual Spring 1999