Program 40 Overview - Toshiba Strata DK40 Programming Manual

Program 40 Station Exchange Line Access

Program 40 Overview

This program is used to allow or deny each station, DISA and Tie lines to use exchange lines
on a line by line basis. This applies to all analogue and digital line types.
Any station can have access to as many lines as desired. Any station denied access (either to
make a call or to answer a call) to a line cannot seize it by dialling either an access or pickup
code or by using an exchange line button. This also denies access via Least Cost Routing.
Also, use this program to divide lines for Tenant Service. Use Program 40 to deny exchange
line call pickup. If only outgoing access is to be prevented but answering incoming calls
should be allowed,
Program 40 does not deny access to answer transferred calls. If the LED for an exchange line
is OFF in this program, access to the line on direct incoming or outgoing calls is denied.
Important! If the DISA port is denied, exchange line access in Program 40, DISA callers
If Tie lines are connected to the DK40 system (PACU, PEMU PCBs), access to other
exchange lines can be denied. The station port assigned to each Tie line is used to deny access
to each exchange line. Station ports 028 ~ 039 are used for Tie lines 1 ~ 12 respectively.
Important! If the Tie line station port is denied access to the exchange line, callers
Strata DK40 Programming Manual Spring 1999
0
Exchange 2
Line LED 8
012
12
011 11
010
10
009 09
008 08
007
07
006 06
005 05
004 04
003 03
002 02
001 01
use Program
cannot access outgoing exchange lines when calling in on DISA lines. Also,
External Call Forward will be blocked on the denied lines. (See DISA port
legend.)
connected to Tie lines cannot access outgoing exchange lines.
Tie Line Station Ports
0 0 0 0 0 0 0
2 3 3 3 3 3 3
9 0 1 2 3 4 5
41, not Program 40 to deny exchange line access.
Toll Restriction
0 0 0 0
3 3 3 3
6 7 8 9
4-5