Led 17: Continuous Dtmf Tones Off - Toshiba Strata DK40 Programming Manual

Program 35 Station Class of Service

LED 17: Continuous DTMF Tones Off

2000-series digital telephones can send DTMF tones for as long as station users press their
buttons (80 msec. minimum). This feature can be disabled (LED 17 ON). If it is disabled,
DTMF tones sent by these telephones will be either 80 or 160 milliseconds depending on the
selection made with
LED 16: No Call Forward/No Answer on Handsfree Answerback
When enabled (LED 16 ON), a Handsfree Answerback call to an idle station in the Call
Forward No-Answer or Call Forward-Busy/No Answer mode is not forwarded. If the system
is Programmed for Voice first
do not Call Forward No-Answer; however, calls will call forward busy. This prevents the call
from being forwarded 8-60 seconds after the called party has been talking in the Handsfree
Answerback mode.
Outside calls and busy internal calls to the station continue to forward with this feature set. If
the system is set for Tone First, calls will call forward on Busy and No Answer.
Notes
LED 06~15
Not used at this time.
LED 05: LCD Individual Message
This option defines which ports can allows LCD digital and electronic telephones to store up
to 10 personal messages. It offers the option of entering alphanumeric memos for each of the
LCD's station speed dial numbers. See the record sheet legend for the maximum stations that
can have this option:
A low port must be disabled (LED 05 OFF) before adding a port above the initialised ports.
LED 04: Message Waiting (RCV)
If the message waiting indication is not desired on an electronic, digital or standard
telephone, this program can be used to deny it. This does not affect that station's ability to
send a message waiting indication to another station ([PDN]). Do not use this option to
enable/disable MW lamps on standard telephones; use LED 03 below for standard
telephones.
LED 03:
Not used at this time.
LED 02: LCD Type 32/12
Digital and 6000/6500-series LCD electronic telephones have 32-character displays.
Therefore, assignments should be left in the initialised state of 32 characters. LED 02 must be
ON to receive the voice mail message waiting indication.
LED 01: LCD Display
This option should be used (LED 01 ON) for all stations (even non-LCD), unless it is desired
to disable the station's LCD and message waiting functions.
Strata DK40 Programming Manual Spring 1999
Program 10-1, LED 04 and
The caller can press the RING Soft Key on digital LCD telephones or press 4 on
digital or electronic telephones to activate Call Forward on Voice Announce calls.
OCA calls do not Call Forward No Answer in any case.
Program
(Program 10-1 and 10-2, LED 01 OFF), Voice Announce calls
Automatic Call Distribution
10-2, LED 06.
6-47