Program 92 Overview; Program 92 Example - Toshiba Strata DK40 Programming Manual

Initialisation & Test

Program 92 Overview

Program 92 clears all previously entered or random data (of the type listed) but does not clear
data in system Programs 00~
CAUTION!
Notes

Program 92 Example

Action (press buttons + LED Buttons)
1. Use the programming LCD electronic or digital
telephone. (See "Step 1: Check Minimum Hardware
Requirements" on Page 1-18 for more
& &4 5 6
2.
- - - -
Enter programming mode. (Do not press [DN] button.)
System beeps after Spkr (Speaker) is pressed to
indicate program number may be entered.
(QWHU >3DVVZRUG@ +ROG
3.
Enter the four digit password.
6SNU +6SHDNHU, <5 +ROG
4.
Access Program 92.
6SNU +6SHDNHU,
5.
Prepare the system for selection of programs to
initialise. For new system installation perform all 1~9.
6HOHFW RQH RI WKH IROORZLQJ1
6.
4 + LED Buttons 01 & 03
Clears Station Speed Dial, Voice Mail ID codes, and
LCD memos assigned to station speed dial numbers.
2-10
99.
*
You must run Program 92 when first installing the system ; if you do not,
the system could begin to operate erratically.
Running Program 92-5 does not affect digital telephone handset receiver
volume levels. Use Program 27 to set off-hook handset receiver volume levels
for digital telephones.
Program 92-9 does not affect Call Forward External or Fixed Call Forward
settings.
You must power the system OFF then back ON to clear telephone LCD Call
Forward Displays and Call Forward button LEDs. Call Forward memory is
cleared when you run Program 92-9, even if system power is not cycled.
Program 92-81 must be run every time a new PCB is installed or is moved to a
different slot location.
information.)
Program 92 Initialising Misc. Backup RAM
LCD Response
20 Jan Sun
Program Mode
Password = ___________
level 1 Program Access
Program = 92
92 Select =
92 Select = 1
Each Dial Clr
Strata DK40 Programming Manual Spring 1999
1
No. N-N
06:43
Data Store