Program *42-2 Secondary Clock Timing Source Reference (Tbsu/Rbsu/Rptu) - Toshiba Strata DK40 Programming Manual

System & Station

Program *42-2 Secondary Clock Timing Source Reference (TBSU/RBSU/RPTU)

Program *42-2
Secondary Clock Timing Source Reference
(TBSU/RBSU/RPTU)
Program Type:
Initialised Default:
(QWHU 3URJ 0RGH 0 6SNU
Enter the TBSU, RBSU or RPTU PCB slot number that
is defined as the secondary reference system timing
source. (Only slots 15 & 17 will support the RDAU and
RPTU PCB)
Program *42-2 Overview
The Secondary Timing Reference is assigned with this program. This is done by entering
the slot number and where applicable the circuit number that is defined as the secondary
reference system timing source.
Important! Please note only TBSU/RBSU PCB's installed with the circuit configured for
WARNING! If the Reset key on the relevant PCB is pressed the data in this Program will
need to be reassigned.
3-98
System
Initialised Data is Blank
7 5 +ROG 0 6SNU
*
RPTU installed - Enter the slot number (15 or 17) and always set the circuit number
to DATA=1
TBSU installed - Enter the slot number (12) followed by the circuit number to be
used (1~2)
RBSU installed - Enter the slot number (15~18) followed by the circuit number to
be used (1~2)
'TE' operation can be used as a secondary reference system timing source.
5 +ROG
Strata DK40 Programming Manual Spring 1999
0 6SNU & & +ROG 0
Enter the RPTU, TBSU circuit number that is
defined as the secondary reference system
timing source. If a RPTU PCB is installed the
Data entered must =1
6SNU & & +ROG