Led 15: Toshiba Stratagy And/Or Vm Integration (A Tone/D Tone); Led 12: Pooled Line Button Operation, No Flash If No Ring; Led 11: Ddi Call Camp On; Led 10: All Call Page Allowed-Digital And Electronic Telephones - Toshiba Strata DK40 Programming Manual

System & Station
LED 15: Toshiba Stratagy and/or VM Integration (A Tone/D
Tone)
When enabled (LED 15 ON), sends an answer tone (DTMF A tone) to the Toshiba voice mail
system when a station answers, and a disconnect tone (DTMF D tone) when a station
disconnects. This allows Toshiba voice mail systems to respond quickly rather than waiting
during long time-outs. If the local exchange provides an Automatic Release (AR) signal
(sometimes referred to as Calling Party Control or Loop Supervision), D tone is also sent to
disconnect VM ports when outside callers hang up

LED 12: Pooled Line Button Operation, No Flash if No Ring

When enabled (LED 12 ON) on telephones assigned to ring in Programs 81~89, incoming
line calls in pooled line groups only flash on 3RROHG /LQH buttons. When disabled (LED
12 OFF), the Pooled Line LED flashes when an incoming line call is received – even if the
telephone does not ring.

LED 11: DDI Call Camp On

This program allows incoming DDI calls to be camped onto busy stations. This can be
enabled on a per station basis.
LED 10: All Call Page Allowed-Digital and Electronic
Telephones
When enabled, (LED 10 ON) any station can be allowed to receive an All Call Page and still
have the ability to initiate an All Call Page. Up to 28 stations can be can be assigned and
paged at one time.
LED 09: No Station plus Exchange Line Conference
Origination by VM
When enabled (LED 09 ON), prohibits VM ports from setting up conference calls with a
station, and the outside line party and tandem calls with two outside lines. Use this feature for
VM (RSTU, PSTU, KSTU3) ports. This LED should be ON when VM/Auto Attendant does
screened or supervised transfers and OFF if only doing blind transfers.

LED 05~08: Voice Mail (VM) Groups 1~4

The system allows the following VM station port groups to be configured for support of VM/
auto attendant devices:
One group is intended for each different device.
All standard telephone ports (RSTU, PSTU, KSTU3) connected to a particular VM machine
should be assigned to the same VM group (DTMF Integration). The purpose of VM grouping
is to allow efficient use of the message waiting (MW) set and cancel operations from the VM
machine. Since each digital, electronic, and standard telephone can only have a maximum of
four messages waiting, the VM device should set MW only once, regardless of how many
messages there are.
3-68
See Program *30
System
DK40
(see Program 15-0 and
for alternative station page group assignments.
Number of VM Groups
1~4
Strata DK40 Programming Manual Spring 1999
Program 31 Station Class of Service
LEDs
05~08
15-3).