Panel Setup - Sony MVS-8000 User Manual

Note that the setup data in RAM can also be saved to the control panel hard disk
or memory card.

Panel Setup

In panel setup, you carry out settings particular to the control panel.
You can make the following settings.
For details of the operations, see "Setup Relating to Operations From the
Control Panel" in Chapter 16 (Volume 2).
Panel settings (Config)
• M/E Assign: Set the logical configuration of the M/E and P/P banks.
• M/E Operation: For each of the M/E and P/P banks, make operations
• Dual M/E Assign: Using two M/E banks, assign the shift and non-shift
• Dual M/E Xpt Swap: When a setting has been made for Dual M/E Assign,
• DSK Fader Assign: Carry out fader function assignment and key delegation
• External Bus Link: Make link settings relating internal switcher buses to
• Key Trans Link: Select whether or not to link transitions between keyers,
• Reference Module: When a trackball module and a joystick module are both
• 10 Key Region Assign: Assign any regions to the region selection buttons
• Program Button: Make settings for using the buttons in a standard type
Cross-point button settings (Xpt Assign)
• Main, V/K Pair Assign: Make cross-point settings for the main table.
178
Setup
each device is recalled when a reset is made or the power is turned back on.
(See "Selecting the start up state (Start Up)" (page 175).)
possible, not possible, or disabled (Enable/Disable/Inhibit).
button rows of a single M/E bank.
swap the shift and non-shift button rows.
for the key delegation buttons, in each of the maximum of four downstream
key control blocks.
routing switcher destinations.
and if so which keyer to link to. You can set the links between keyers for each
M/E bank separately.
connected as device control blocks, select which is used as the reference.
in the numeric keypad control block. Also used for setting the regions
included in the selection when the [All] button is pressed.
transition control block for controlling a VTR and for assigning the Flexi Pad
control block to macro operation.
– Assign video/key sources for button numbers 1 to 128.