Sony MVS-8000 User Manual page 299

Setting the transition rate in the Flexi Pad control block
Note
In the PGM/PST bank or when using a simple-type transition control block,
you cannot use the Flexi Pad control block to set the transition rate.
Use the following procedure.
1
In the M/E bank Flexi Pad control block, press the [TRANS RATE]
button.
The memory recall section display is now ready to accept the entered
transition rate.
TC button
2
Enter the desired transition rate with the numeric keypad.
If required, press the [TC] button to toggle the input mode (frame input or
timecode input).
• Enter a value of up to three digits.
• To cancel the entry, press any of the six buttons in the leftmost column
([WIPE], [DME], ...) or the [TRANS RATE] button.
3
Press the [ENTR] button.
This confirms the entry, and the new setting appears in the transition
control block display.
XPT HOLD
WIPE
A B U U 1 2 3 4
1 2
DME
7 8 9
SNAP
SHOT
4 5 6
EFF
1 2 3
SHOT
BOX
0
MCRO
Flexi Pad control block (standard type)
UNDO
STORE
STATS
TRANS RATE button
TRANS
RATE
BNAK
0
BANK
1
BANK
SEL
ENTR button
Memory recall section
Executing a Transition
299