Sony MVS-8000 User Manual page 180

External device connections (Device Interface)
• GPI Input: Set the GPI input ports and trigger type, and make the action
• GPI Output: Set the GPI output ports and trigger type, and make the action
• P-Bus Control: Set the control mode for P-Bus devices.
• DCU Serial Port Assign: Assign the devices (disk recorder/VTR/Extended
• Editor Port Assign: When the BZS-8050 license is valid, make settings for
Operation settings (Operation)
• Button Tally: Set whether or not the system tally generation results are
• Trans Rate Display: Select whether the transition rate display mode is in
• S-Bus Name Link: Copy the S-Bus description name to the source name.
• Effect: For keyframe effects, you can make the following settings. (See
• Source/Dest Name: For the Source/Dest (source/destination) names used by
• Name Display: Specify the number of characters for display of the names
180
Setup
disabling functions (recalling utility commands) and recalling shotbox
registers or macro registers.
settings.
settings.
VTR) connected to a DCU and accessible from the control panel to the
[DEV1] to [DEV12] buttons which become operative when you press the
[DEV] button on the device control block. For a disk recorder or Extended
VTR, you can also make settings relating to sharing of file lists. Further, you
can make settings for devices (disk recorder/VTR/Extended VTR) operable
from an editing keyboard.
the SCU editor panel port.
reflected in the panel tally.
frames or timecode units.
Chapter 13 "Keyframe Effects" (Volume 2).)
– Recall mode
– Automatically turning off the [EDIT ENBL] button when an effect is
recalled
– Automatic insertion of a first keyframe when an empty register is recalled
– Effect Auto Save
– Default KF Duration
– Setting whether or not to replay the first keyframe after rewinding a GPI/
P-Bus/disk recorder/VTR/Extended VTR effect
the system, select one of the following:
– Source name set by cross-point assignment or fixed bus name
– Description name set on routing switcher
– "Type + Num" name set on routing switcher
Names assigned with Xpt Assign can be replaced later with description
names.
selected in Source/Dest Name above, as two characters, four characters, or
Auto.