Knob
2
a) See page 61.
To move the pattern from its current position to the center through
the course of a transition
Press [Auto Center] in the <Position> group, turning it on.
Rotating the wipe pattern (Rotation)
Use the following procedure.
1
In the <Rotation> group of the Key1 Wipe Adjust menu, select the rotation
type.
Angle: Incline the pattern through a fixed angle.
Speed: Rotate at a speed rate.
Magnitude: Rotate the pattern through a fixed angle during the course of
the transition.
2
According to the selection in step 1, set the following parameters.
• When Angle is selected
Knob
1
a) See page 61.
• When Speed is selected
Knob
1
a) See page 62.
• When Magnitude is selected
Knob
1
2
a) See page 62.
Parameter
Adjustment
Position V
Vertical position
Parameter
Adjustment
Angle
Angle of pattern rotation
Parameter
Adjustment
Speed
Rotation rate of pattern
Parameter
Adjustment
Angle
Angle of pattern rotation at start of
transition
Magnitude
Angle of rotation through course
of transition
Setting values
–200.00 to +200.00
Setting values
–100.00 to +100.00
Setting values
–100.00 to +100.00
Setting values
–100.00 to +100.00
–200.00 to +200.00
Wipe Settings for Independent Key Transitions
a)
a)
a)
a)
a)
393