Resetting of parameter values set in the source coordinate space
In some transformation operation modes, if you switch to the target coordinate
space after setting up a three-dimensional transformation in the source
coordinate space, the setting values in the source coordinate space (three-
dimensional parameter values) are converted to values in the target coordinate
space (source/target conversion).
Once a conversion has taken place, the original source coordinate space
parameters do not return to their original values when you switch back to the
source coordinate space. They are reset to zeros.
Source/target conversion occurs in the following operation modes:
• Location XYZ
• Rotation
Transformation Operation Modes
The following operation modes are available for three-dimensional DME
transformations. These operations are carried out in the device control block.
(For details, see "Three-Dimensional Transformation Operations" in Chapter
11 (Volume 2).)
Location XYZ
Moves the image on the x-axis, y-axis, or z-axis. The direction of movement
differs depending on whether you are manipulating the image in the source
coordinate space or the target coordinate space.
Image movement in the source coordinate space
Movement on the x-axis
102
Digital Multi Effects (DME)
Movement on the y-axis
Movement on the z-axis