Sony MVS-8000 User Manual page 407

2
Depending on whether the selected pattern is in one-channel mode or two-
channel mode, proceed as follows.
For a pattern in one-channel mode: in the <Ch Select> group, press [1st
Ch], turning it on.
For a pattern in two-channel mode: from the <Ch Select> group, select
the corresponding channels. You can select more than one channel at
the same time.
3
In the <Crop Mode> group, press [Crop] or [4:3 Crop] (to crop from 16:9
to 4:3 aspect ratio), turning it on.
4
In the <Crop Mode> group, press [Remove From Begin].
The Remove From Begin menu appears.
5
In the <Crop Transition> group, select the execution mode for the DME
wipe crop transition.
Cut: Cut mode. The cropping does not change during the transition, but at
the end point of the transition the cropping is removed (enlarges).
Last 5%: The cropping is maintained for the first 95% of the transition,
and is progressively removed during the last 5% of the transition
(enlarges).
Linear: The cropping is removed linearly through the whole course of the
transition (enlarges).
Transition
Cropping
y
(%)
100
0
100 (%)
[Cut]
t: transition execution time
y: change in transition and cropping amount
Transition
Cropping
y
(%)
100
95
t
0
95
[Last 5%]
Transition
Cropping
y
(%)
100
t
0
100 (%)
[Linear]
Basic Procedure for DME Wipe Settings
t
100 (%)
407