Sony MVS-8000 User Manual page 29

In addition to the signals input to the PRIMARY INPUTS 1 to 80 connectors
on the rear panel of the switcher, you can also select signals generated within
the switcher.
Each button has assigned to it a video signal and a key signal, forming a pair.
You can set these video and key combinations in a Setup menu.
For details of Setup menu operations, see "Cross-Point Settings (Xpt Assign
Menu)" in Chapter 16 (Volume 2).
Cross-point button control block button numbers
1, 2, 3, 4, .......
32, 33, 34, 35, .......
On each M/E bank and the PGM/PST bank, each cross-point button and reentry
button has two button numbers, and you use the shift button to switch between
these numbers.
In the case of a 32-button layout, the button numbers are as follows.
Button
From the left end to the 31st
button
Reentry buttons
Note
On the MVS-8000A, you can use the rightmost button (number 32) as a [SIDE
FLAG] button. In this case, the shift button moves one to the left, to number
31, and the button numbers are offset by one.
For details of the [SIDE FLAG] button, see "Cross-Point Settings (Xpt Assign
Menu)" in Chapter 16 (Volume 2).
(first button numbers)
(second button numbers)
Cross-point control block button numbers
Number when the shift
button is not pressed
1 to 31
121 to 123
Shift button
M/E M/E
1 2
M/E M/E
1 2
SHIFT
M/E M/E
1 2
M/E M/E
1 2
....... 29, 30, 31 121 123
....... 60, 61, 62 125 127
Shift button
Number when the shift
button is pressed
32 to 62
125 to 127
Signal Selection
M/E XPT
DSK3
3 HOLD
M/E XPT
KSK4
3 HOLD
MCRO MCRO
ENBL ASGN
M/E XPT AUTO
3 HOLD RUN
M/E XPT
UTIL
3 HOLD
29