• Pattern Key: pattern key
• Ext Key: external key
(This can only be selected when the pair mode is enabled. The signal
selected on the frame memory source 2 bus is used as the key signal.)
• Mix: mix
• Nam: non-additive mix
If none of the above is selected, image combination is not carried out.
2
Depending on the selection in step 1, set the following parameters.
• When [Pattern Key] is selected
Knob
Parameter
1
Size
2
Soft
3
Pattern
a) The patterns are the same as for a standard wipe. See the appendix "Wipe Pattern List"
(Volume 2).
• When [Ext Key] is selected
Knob
Parameter
1
Clip
2
Gain
• When [Mix] is selected
Knob
Parameter
1
Mix Rate
3
When you selected a pattern key, press [Pattern Adjust].
The Pattern Adjust menu appears. In the menu, set the pattern modifiers as
required.
• When turning [Position] on and setting the pattern position
Knob
Parameter
1
Position H
2
Position V
a) See page 61.
• When turning [Multi] on and replicating the pattern
Adjustment
Size of pattern
Edge softness of pattern
Pattern number
Adjustment
Reference level for key
signal generation
Key sensitivity
Adjustment
Mix proportion
Adjustment
Horizontal position
Vertical position
Setting values
0.00 to 100.00
0.00 to 100.00
a)
1 to 24
Setting values
+109.59 to –7.31
–100.00 to +100.00
Setting values
0.00 to 100.00
Setting values
a)
–100.00 to +100.00
a)
–100.00 to +100.00
Frame Memory Operations
431