Sony MVS-8000 User Manual page 403

Knob
1
3
4
5
• When soft border is selected
Knob
1
2
3
4
5
Display indications when multiple channels are selected at the same
time
The indications on the knobs show the settings of the lowest-numbered
channel. When you turn the knobs to adjust the settings, this changes the
settings on the other channels by the same amount.
Setting the DME wipe position (Positioner)
Use the following procedure.
1
In the M/E-1>DME Wipe menu, select HF5 'Modify.'
The Modify menu appears.
2
Depending on whether the DME wipe pattern is in one-channel mode or
two-channel mode, proceed as follows.
For a pattern in one-channel mode: press [1st Ch], turning it on.
For a pattern in two-channel mode: from the <Ch Select> group, select
the corresponding channel. You can select more than one channel at
the same time.
3
In the <Position> group, press [Position], turning it on.
4
Set the following parameters.
Knob
1
Parameter Adjustment
Width Border width
Luminance Luminance
Saturation Saturation
Hue Hue
Parameter Adjustment
Width Border width
Inner Soft Border inner softness
Luminance Luminance
Saturation Saturation
Hue Hue
Parameter Adjustment
H Horizontal position
Setting values
0.00 to 100.00
0.00 to 100.00
0.00 to 100.00
359.99 to 0.00
Setting values
0.00 to 100.00
0.00 to 100.00
0.00 to 100.00
0.00 to 100.00
359.99 to 0.00
Setting values
–200.00 to +200.00
Basic Procedure for DME Wipe Settings
403