Sony MVS-8000 User Manual page 175

Signal format
1080PsF/29.97,
1080i/59.94
1080PsF/25, 1080i/50
1080PsF/23.976
1080PsF/30, 1080i/60
1080PsF/24
720p/59.94
720p/50
a) Interlock mode
Selecting the start up state (Start Up)
Set the initial state of the devices when the system is powered on.
For each device, you can select Resume mode or Custom mode.
Resume mode
This resumes the setting state at the previous power-off operation. This setting
is only available for the switcher processor and panel.
Custom mode
This uses the settings saved in non-volatile memory or ROM within the device.
In this mode, there are Setup and Initial Status settings which can be set
separately.
• Setup mode: Select the setup state to be used after powering on from the
following.
User: Start up using the user data previously saved with [Setup Define].
Factory: Start up with the factory default settings.
• Initial status mode: Select the state of each device after powering on
(excluding the settings to which "setup" applies).
User: Start up using the user data previously saved with [Initial Status
Define]. For the control panel, this applies to the key bus delegation
buttons only.
Factory: Start up with the factory default settings.
For details of saving and recalling setup data, see "Saving and Recalling Setup
Data" (page 177) and the appendix "Data Saved by [Setup Define] and [Initial
Setup Define]" (Volume 2).
Input reference signal
Tri Sync Black burst
59.94 Black Burst 59.94
50 Black Burst 50
47.952
Black Burst 59.94
60 –
48 –
59.94 Black Burst 59.94
– Black Burst 50
Sync 59.94
Sync 50
a) a)
Sync 59.94
Sync 59.94
Sync 50
Setup
175