Sony MVS-8000 User Manual page 300

Setting the transition rate in the numeric keypad control block
Use the following procedure.
1
2
3
4
300
Executing a Transition
TRANS RATE button
SNAP SHOT
EFF MCRO
SHOT BOX
MASTR ALL P-BUS
M/E M/E M/E
P/P
1 2 3
USER USER USER USER
1 2 3 4
DME DME DME DME
1 2 3 4
DME DME DME DME
5 6 7 8
Region selection buttons
Numeric keypad control block
In the numeric keypad control block, press the [TRANS RATE] button.
Press the region selection button for the M/E or PGM/PST bank for which
you want to set the transition rate, turning it on.
The numeric keypad control block display now shows the selected region
name and the current transition rate setting for the region.
With the numeric keypad, enter the transition rate.
If required, press the [TC] button to toggle the input mode (frame input or
timecode input).
• Enter a value of up to three digits.
• To clear the entry, press the [CLR] button.
Press the [ENTER] button.
This confirms the entry, and the selected region name and the set transition
rate appear in the numeric keypad control block display.
The transition control block display of the same bank (M/E or PGM/PST)
also shows the setting.
Display
TRANS
UNDO
RATE
STORE
GP1
STATS
8
7
TC
4 5
RTR
2
1
DEV STORE
1
DEV
0
RCALL
2
TC button ENTER button
Numeric keypad
+/-
9
EFF
DISS
CLR
6 AUTO
TRANS
TRIM
XPT
3
ENBL
ENTER