Sony MVS-8000 User Manual page 402

Specifying the DME wipe direction (Direction)
You can specify the DME wipe direction (normal/reverse).
To specify the DME wipe direction in a menu
Use the following procedure.
1
2
To specify the DME wipe direction with a button in the transition
control block
In the transition control block of each of the M/E-1 to M/E-3 and PGM/PST
banks, press the following direction selection buttons.
NORM: Normal
NORM/REV: Normal/Reverse
REV: Reverse
Modifying the DME wipe pattern edge
Use the following procedure.
1
2
3
4
402
Basic Procedure for DME Wipe Settings
In the M/E-1>DME Wipe menu, select HF4 'Edge/Direction.'
The Edge/Direction menu appears.
In the <Direction>group, specify the DME wipe direction.
Normal: regular direction
Normal/Reverse: alternate between regular and reverse for each transition
Reverse: reverse direction to normal
In the M/E-1>DME Wipe menu, select HF4 'Edge/Direction.'
The Edge/Direction menu appears.
Depending on whether the selected pattern is in one-channel mode or two-
channel mode, proceed as follows.
For a pattern in one-channel mode: press [1st Ch], turning it on.
For a pattern in two-channel mode: from the <Ch Select> group, select
the corresponding channel. You can select more than one channel at
the same time.
In the <Edge> group, select the edge type.
Border: border
Soft Border: soft border
Set the parameters according to the selection in step 3.
• When border is selected