Sony MVS-8000 User Manual page 176

Autoload function
Switch on or off the function to automatically load predetermined register data
or frame memory image data at power on. Set the data to be read in the File
menu.
System reset and memory initialization (Initialize)
• Reset: Reset to state after powering on.
• All Clear: Clear the memory, and carry out initialization. The Network
For more details, see "Saving and Recalling Setup Data" (page 177).
Installation and device settings (Install/Unit Config)
This installs the software and firmware in all devices (including the DCU)
connected to the Data LAN.
Install: Automatically detects the software that can be installed on each device,
There are also the following functions.
Detail Information: Gives details of the software and firmware installed in
Unit Config: Carries out device settings. Switches the color corrector function
License: Makes the license valid or invalid.
Device management (Maintenance)
• Date and time setting
• Formatting a memory card
• Primary settings for USB external storage device
• Reloading a USB driver
• Formatting the hard disk
• Locking setup menu operations
176
Setup
Config, System Config, Format, and Start Up setup values are set by
reference to data stored in non-volatile memory, and the system
automatically starts up. It is not necessary to reset the Date/Time settings.
and installs the selected software.
each device.
of the switcher processor between secondary color correction and spot
color adjustment.
– For each VF button group, selecting a set of candidate menus to be locked,
then locking all of the candidates using a password. Except for list
scrolling, moving menus, and similar operations, menu operations for all
settings can be locked.
– Changing the password