Sony MVS-8000 User Manual page 101

Detents
The system defines points called detents at regular intervals on the three-
dimensional space. Pressing the [CTR] button in the device control block sets
the current three-dimensional parameter values to the closest detent points.
(For details, see "Three-Dimensional Transformation Operations" in Chapter
11 (Volume 2).)
The following table shows the interval between successive detents for each
transformation operation mode (see page 102).
Operation mode
Location XYZ
Rotation, Spin
Axis Location
Location Size
Aspect
Perspective (x, y)
Perspective (z)
Skew
a) When a value is smaller than 1, 1/Aspect or 1/Perspective (z) is adjusted to an integral value.
Three-dimensional parameter default values
Each of the transformation operation modes has default values for three-
dimensional parameters. If required, you can return the current value to the
defaults by pressing the [CTR] button in the device control block twice in rapid
succession. (For details, see "Three-Dimensional Transformation
Operations" in Chapter 11 (Volume 2).)
The following table shows the default parameter values for each
transformation operation mode.
Operation mode
Location XYZ
Rotation, Spin
Axis Location
Location Size
Aspect
Perspective (x, y)
Perspective (z)
Skew
Detent interval
1.00
0.25
1.00
0.25
a)
1.00
1.00
a)
1.00
0.10
Default value
0.00
0.00
0.00
1.00
1.00
0.00
1.00
0.00
Digital Multi Effects (DME)
101