Drive-Cliq Hub Module Dmc20; Diagnostics Via Starter - Siemens SINAMICS S120 Commissioning Manual

Diagnosis

3.2 Diagnostics via STARTER

3.1.20

DRIVE-CLiQ Hub Module DMC20

Table 3-22 DRIVE-CLiQ Hub Module DMC20 – description of the LEDs
LED Color
READY -
Green
Orange
Red
Green/
red
Green/
orange
or
Red/
orange
3.2 Diagnostics via STARTER
Description
The diagnostic functions support commissioning and service personnel during
commissioning, troubleshooting, diagnostics and service activities.
General information
Prerequisites: Online operation of STARTER.
The following diagnostic functions are available in STARTER:
● Specifying signals with the ramp-function generator
● Signal recording with the trace function
● Analyzing the control response with the measuring function
● Outputting voltage signals for external measuring devices via test sockets
128
State
OFF Electronics power supply is missing or outside permissible
tolerance range.
Continuous The component is ready for operation and cyclic DRIVE-
CLiQ communication is taking place.
Continuous DRIVE-CLiQ communication is being established.
Continuous At least one fault is present in this component.
Note:
The LED is activated regardless of whether the
corresponding messages have been reconfigured.
Flashing Firmware is being downloaded.
0.5 Hz
Flashing Firmware download is complete. Wait for POWER ON
2 Hz
Flashing Component recognition via LED is activated (p0154).
Note:
Both options depend on the LED status when component
recognition is activated via p0154 = 1.
Description, cause
Commissioning Manual, (IH1), 07/2007 Edition, 6SL3097-2AF00-0BP7
Remedy
–
–
–
Remedy and
acknowledge fault
–
Carry out a POWER
ON
–
Commissioning