Voltage Sensing Module Vsm10 - Siemens SINAMICS S120 Commissioning Manual

LED Color
Red
Orange
3.1.19

Voltage Sensing Module VSM10

Table 3-21 Voltage Sensing Module VSM10 – description of LEDs
LED Color
READY -
Green
Orange
Red
Green/
red
Green/
orange
or
Red/
orange
Commissioning
Commissioning Manual, (IH1), 07/2007 Edition, 6SL3097-2AF00-0BP7
State
Continuous Cyclic communication via PROFINET has not yet been
established. However, non-cyclic communications are
possible. SINAMICS waits for a
parameterizing/configuring telegram
Flashing The firmware has not been successfully downloaded to
0.5 Hz the CBE20 (error).
Possible causes:
The CBE20 is defective.
•
The CF card for the Control Unit is defective.
•
In this state CBE20 cannot be used.
Flashing Communication between the Control Unit and CBE20 is
2.5 Hz faulty.
Possible causes:
Board was withdrawn after booting.
•
The board is defective
•
Flashing Firmware is being downloaded.
2.5 Hz
State
OFF Electronics power supply is missing or outside permissible
tolerance range.
Continuous The component is ready for operation and cyclic DRIVE-
CLiQ communication is taking place.
Continuous DRIVE-CLiQ communication is being established.
Continuous At least one fault is present in this component.
Note:
The LED is activated regardless of whether the
corresponding messages have been reconfigured.
Flashing Firmware is being downloaded.
0.5 Hz
Flashing Firmware download is complete. Wait for POWER ON
2 Hz
Flashing Component recognition via LED is activated (p0144)
Note:
Both options depend on the LED status when component
recognition is activated via p0144 = 1.
Description, cause
Description, cause
Diagnosis
3.1 Diagnostics via LEDs
Remedy
–
–
Correctly insert the
board, if required,
replace.
–
Remedy
–
–
–
Remedy and
acknowledge fault
–
Carry out a POWER
ON
–
127