Siemens SINAMICS S120 Commissioning Manual page 105

Module
CUA31
CUA32
TM31
SME120/
SME125
Active Line Module
Basic Line Module
Motor Module
Commissioning information
The index [0..n] used in the following identifies either the motor data set or the encoder data
set.
SMC10/SMC20
The parameterization of the motor temperature evaluation via the sub D socket X520 can be
performed using the Starter screen (signals and monitoring \ Motor temperature).
SMC30 (only as of Order No. 6SL3055-0AA00-5CA2 and firmware 2.5 SP1)
In addition to the temperature evaluation via terminal X531, this module also has a
temperature evaluation at the sub D socket X520.
The parameterization of the motor temperature evaluation via the sub D socket X520 must
be performed in the expert list as follows:
Commissioning
Commissioning Manual, (IH1), 07/2007 Edition, 6SL3097-2AF00-0BP7
2.13 Temperature sensor connections for SINAMICS components
Interface Pin
This temperature channel is only available as of Order No. 6SL3040-0LA00-0AA1 and
2)
FW 2.5 SP1.
The associated temperature channel (T1) can be parameterized as a single channel or in
combination with the second temperature channel (T2) at interface X120.
X210 (terminal) 1
2
X210 (terminal) 1
Temperature 2
channel 2
X220 (sub D) 1
Temperature 8
channel 1
X522 (terminal) 7
8
X200 (connector) 1
Temperature 2
channel 2
X200 (connector) 3
Temperature 4
channel 3
X200 (connector) 5
Temperature 6
channel 4
X21 (terminal) 1
2
X21 (terminal) 1
2
X21/X22 (terminal) 1
2
Signal name Technical specifications
+Temp Temperature sensor connection
- Temp KTY84–1C130 / PTC
+Temp Temperature sensor connection
- Temp KTY84–1C130 / PTC
+Temp KTY or PTC input
- Temp Ground for KTY or PTC
+Temp Temperature sensor connection
- Temp KTY84–1C130 / PTC
- Temp Temperature sensor connection
+Temp KTY84–1C130
PTC connection Connection, PTC triplet 1 or
PTC connection bimetal 1
PTC connection Connection, PTC triplet 2
PTC connection
+Temp Temperature sensor connection of
- Temp the Active Line Module
+Temp Temperature sensor connection of
- Temp the Basic Line Module
Temperature switch type:
bimetallic-element switch with NC
contact
+Temp Temperature sensor connection
- Temp KTY841–C130 / PTC
Commissioning
105