Siemens SINAMICS S120 Commissioning Manual page 106

Commissioning
2.13 Temperature sensor connections for SINAMICS components
● p0600[0..n]: Selection of the encoder (1, 2 or 3) to which the SMC30, that is used for the
● p0601[0..n] = 10 (evaluation via several temperature channels), n = motor data set.
● p4601[0..n]: Select the temperature sensor type for temperature channel 2 (depends on
Note
With several encoders, the index [n] of the relevant encoder / encoder data set, via which
the temperature evaluation is performed, must be used.
Example:
A KTY temperature sensor is connected at the sub D socket X520 on the SMC30 of
Encoder 1.
This is parameterized via:
● p0600[0..n] = 1 / p0601[0..n] = 10 / p4601[0..n] = 20
Both temperature channels (X520 and X531) can be used at the same time. In addition to
the above parameterization, the sensor type of the temperature sensor connected at terminal
X531 must be entered in p4600[0..n]. The maximum value is then generated for the motor
temperature and displayed in r0035.
CU310 (all hardware versions and firmware 2.4)
Only the temperature evaluation can be performed via terminal X120.
The parameterization of the motor temperature evaluation can be performed using the
Starter screen (\Signals and monitoring \ Motor temperature). "Temperature sensor via Motor
Module (11)" should be selected in the "Temperature sensor selection" field.
CU310 (Order No. 6SL3040-0LA00-0AA0 and firmware 2.5 SP1)
Only the temperature evaluation can be performed via terminal X120.
The parameterization of the motor temperature evaluation can be performed using the
Starter screen (\Signals and monitoring \ Motor temperature). The encoder number of the
internal encoder evaluation should be selected in the "Temperature sensor selection" field. If,
for example, the internal encoder evaluation is used as Encoder 1, "Temperature sensor via
Encoder 1 (1)" should be selected.
CU310 (as of Order No. 6SL3040-0LA00-0AA1 and firmware 2.5 SP1)
In addition to the temperature evaluation via terminal X120, a temperature sensor can also
be connected at sub D socket X23 on this module.
The parameterization of the motor temperature evaluation via the sub D socket X23 can be
performed using the Starter screen (\Signals and monitoring \ Motor temperature). The
encoder of the internal encoder evaluation should be selected in the "Temperature sensor
selection" field.
If the temperature evaluation is to be performed via terminal X120, the following
parameterization must be entered via the expert list:
106
temperature evaluation, is assigned (n = motor data set).
encoder data set n, not motor data set).
Commissioning Manual, (IH1), 07/2007 Edition, 6SL3097-2AF00-0BP7
Commissioning