Terminal Module Tm41 - Siemens SINAMICS S120 Commissioning Manual

LED Color
Red
Green/
red
Green/
orange
or
Red/
orange
3.1.15

Terminal Module TM41

Table 3-17 Terminal Module TM41 - description of LEDs
LED Color
READY -
Green
Orange
Red
Green/
red
Green/
orange
or
Red/
orange
Z pulses –
Red
Green
Commissioning
Commissioning Manual, (IH1), 07/2007 Edition, 6SL3097-2AF00-0BP7
State
Continuous At least one fault is present in this component.
Note:
The LED is activated regardless of whether the
corresponding messages have been reconfigured.
Flashing Firmware is being downloaded.
0.5 Hz
Flashing Firmware download is complete. Wait for POWER ON
2 Hz
Flashing Component recognition via LED is activated (p0154).
Note:
Both options depend on the LED status when component
recognition is activated via p0154 = 1.
State
OFF Electronics power supply is missing or outside permissible
tolerance range.
Continuous The component is ready for operation and cyclic DRIVE-
CLiQ communication is taking place.
Continuous DRIVE-CLiQ communication is being established.
Continuous At least one fault is present in this component.
Note:
The LED is activated regardless of whether the
corresponding messages have been reconfigured.
Flashing Firmware is being downloaded.
0.5 Hz
Flashing Firmware download is complete. Wait for POWER ON.
2 Hz
Flashing Component recognition via LED is activated (p0154).
Note:
Both options depend on the LED status when component
recognition is activated via p0154 = 1.
OFF Zero marker found; wait for zero marker output; OR
component switched off.
Continuous Zero mark not enabled or zero mark search.
Continuous Stopped at zero mark.
Flashing Zero mark is output at each virtual revolution.
Description, cause
Description, cause
Diagnosis
3.1 Diagnostics via LEDs
Remedy
Remedy and
acknowledge fault
–
Carry out a POWER
ON
–
Remedy
–
–
–
Remedy and
acknowledge fault
–
Carry out a POWER
ON
–
–
–
–
–
123