Siemens SINAMICS S120 Commissioning Manual page 107

● p0600[0..n]: Selection of the encoder (1, 2 or 3) to which the internal encoder evaluation,
● p0601[0..n] = 10 (evaluation via several temperature channels), n = motor data set.
● p4601[0..n]: Select the temperature sensor type (depends on encoder data set n, not
Both temperature channels (X23 and X120) can be used at the same time. In addition to the
above parameterization, the sensor type of the temperature sensor connected at sub D
socket X23 must be entered in p4600[0..n]. The maximum value is then generated for the
motor temperature and displayed in r0035.
CUA31
The parameterization of the temperature evaluation via terminal X210 can be performed
using the Starter screen (\Signals and monitoring \ Motor temperature). "Temperature sensor
via Motor Module (11)" should be selected in the "Temperature sensor selection" field. The
temperature of the sensor is displayed in r0035.
CUA32
The parameterization of the temperature evaluation via terminal X210 or sub D socket X220
is performed in the same way as described above for the CU310 with two temperature
channels.
TM31
With Terminal Module TM31, the sensor type used is set via p4100 and the temperature
signal interconnected via r4105.
SME120/SME125
For modules with several temperature sensor connections (SME Modules), the temperature
sensor is selected depending on encoder data set n via parameters p4601[0..n]..p4603[0..n].
A maximum of three motor temperature sensors can be evaluated simultaneously via
terminal X200.
The parameterization of the motor temperature evaluation via terminal X200 must be
performed in the expert list as follows:
● p0600[0..n]: Selection of the encoder (1, 2 or 3) to which the SME Module, that is used
● p0601[0..n] = 10 (evaluation via several temperature channels), n = motor data set.
● p4601[0..n]-p4603[0..n]: Select the temperature sensor type of temperature channel 2-4,
● Parameter r4620[0...3] Motor temperatures SME
Commissioning
Commissioning Manual, (IH1), 07/2007 Edition, 6SL3097-2AF00-0BP7
that is used for the temperature evaluation, is assigned (n = motor data set).
motor data set).
Note
With several encoders, the index [n] of the relevant encoder / encoder data set, via which
the temperature evaluation is performed, must be used.
for the temperature evaluation, is assigned (n = motor data set).
depending on encoder data set n.
Only temperature channels 2-4 are available at terminal X200.
is used to display the current temperatures in the motor, measured via an SME120 or
2.13 Temperature sensor connections for SINAMICS components
Commissioning
107