Sample Wiring Of Vector Drives Connected In Parallel - Siemens SINAMICS S120 Commissioning Manual

Preparations for Commissioning
1.5 Rules for wiring with DRIVE-CLiQ
Figure 1-8 Drive line-up (chassis) with different pulse frequencies
1.5.3

Sample wiring of Vector drives connected in parallel

Drive line-up with two parallel-connected Line Modules and Motor Modules (chassis) of the same type
Parallel-connected Line Modules (chassis) and Motor Modules (chassis) of the same type
can be connected to a DRIVE-CLiQ interface of the Control Unit.
In the following diagram, two Active Line Modules and two Motor Modules are connected to
the X100 and X101 interface.
For further information about parallel connection, see the Function Manual.
Note
This topology does not match the topology created offline by STARTER and must be
changed.
30
Commissioning Manual, (IH1), 07/2007 Edition, 6SL3097-2AF00-0BP7
Commissioning