Setting The Start Bartack Parameter (Start Tack); Set End Bartack Parameter (End Tack); Setting The Thread Cutter Parameter (Thread Trim); Setting The Daily Piece Counter (Dailypieces) Parameter - Dürkopp Adler 867-M PREMIUM Service Instructions Manual

Programming

20.4.5 Setting the Start bartack parameter (Start Tack)

Setting whether the start bartack is automatically activated in a new program.
Menu item
ON
OFF

20.4.6 Set End bartack parameter (End Tack)

Setting whether the end bartack is automatically activated in a new program.
Menu item
ON
OFF

20.4.7 Setting the Thread cutter parameter (Thread Trim)

Setting whether the thread cutter is automatically activated in a new pro-
gram or not.
Menu item
ON
OFF

20.4.8 Setting the daily piece counter (DailyPieces) parameter

The daily pieces counter can count upward or downward. It is also possi-
ble to enter the value to be selected when the counter is reset.
Menu item
Cnt Mode
Reset
Service Instructions 867-M PREMIUM - 03.0 - 05/2017
Setting option
The start bartack is activated automatically. The values for the start
bartack are taken from the Manual mode.
The start bartack is not activated.
Setting option
The end bartack is activated automatically. The values for the end
bartack are taken from the Manual mode.
The end bartack is not activated.
Setting option
The thread cutter is activated automatically at the end of a seam
section and at the end of the sewing program.
The thread cutter is not activated.
Setting option
OFF – the counter is off
Up – the daily pieces counter counts upward
Down – the daily pieces counter counts downward
Enter the value to which the daily pieces counter should return when it
is reset (value range -999 - 999).
105