Setting The Stitch Length (Stitchlen.) Parameter; Setting The Bobbin (Bobbin) Parameter - Dürkopp Adler 867-M PREMIUM Service Instructions Manual

Programming

20.5.8 Setting the stitch length (Stitchlen.) parameter

Various settings can be made for the stitch length. The possibilities are
explained in more detail in the table.
Menu item
MaxSt.Len.
ManSt.Len.
Speed Limitati Stitchlen.

20.5.9 Setting the Bobbin (Bobbin) parameter

Various settings can be made for the bobbin. The possibilities are explained
in more detail in the table.
Menu item
Bobbin Monit Activation of the bobbin rotation monitor
SSD
BRM
Service Instructions 867-M PREMIUM - 03.0 - 05/2017
NOTICE
Property damage may occur!
The machine and the sewing equipment may be damaged.
ALWAYS enter the maximum possible stitch length after changing
the sewing equipment.
Setting options
Maximum stitch length possible during sewing; this will vary depend-
ing on the sewing equipment and MUST be adjusted when changing
the sewing equipment.
When the value is changed, the machine requests a reset, i.e.
switching off and on again. Cf.  p. 22.
(Value range 02.0 – 12.0 [mm], depending on subclass)
Stitch adjustment lever for manual adjustment of the stitch length
active or inactive; optional equipment.
(Value range ON/OFF)
The speed is limited during sewing as from the set stitch length
value.
(Value range 1.0 – 12.0 [mm], depending on subclass)
Speed
Value for limiting the speed as from a defined, adjustable stitch
length.
(Value range 0050 – 3800 [rpm], depending on subclass)
Setting options
0 = PCB 9850 867003
1 = CAN version (right bobbin)
2 = CAN version (right and left bobbin)
Enlacement check (only when Bobbin Monit not set to 2)
(Value range ON/OFF)
Bobbin rotation monitor (only when Bobbin Monit not set to 2)
(Value range ON/OFF)
Stitches
Delayed stitches before the bobbin rotation monitor starts.
(Value range 000 – 255)
113