Setting The Stitch Functions (Stitchfunctions) Parameter - Dürkopp Adler 867-M PREMIUM Service Instructions Manual

A mode can be allocated to every output (parameter T 56 00).
The following table lists the modes:

20.6.5 Setting the Stitch functions (StitchFunctions) parameter

The machine counts the stitches when a program is processed with the
pedal. If the operator sews half stitches or full stitches manually, they can
also be counted, if required. To do so, this function must be active.
The electronic handwheel is not affected by this setting.
122
Mode Function
0 No function
1 Needle cooling
2 Cleaning signal for the residual thread monitor
3 Pos 1 (needle down)
4 Pos 2 (top of stroke)
5 Motor running signal
6 Puller/seam center guide
7 Sewing foot lift signal
Service Instructions 867-M PREMIUM - 03.0 - 05/2017
Programming