Setting The Service Routine (Adjustments) Parameter; Setting The Calibration (Calibration) Parameter - Dürkopp Adler 867-M PREMIUM Service Instructions Manual

Test Pedal subitem
This subitem is used to check the various pedal positions of the analog
pedal (X6b). The positions are indicated by measured and automatically
calculated calibration values.
Fig. 99: Test Pedal subitem
Test Fabric Sen. subitem
Use this subitem to test the functionality of the material thickness detection.
Fig. 100: Fabric Sen. subitem

20.7.2 Setting the Service routine (Adjustments) parameter

The Adjustments parameter is not explained in greater detail here,
because it is closely to the area of the mechanics. Details on that area can
be found in the Service routine chapter ( p. 14).

20.7.3 Setting the Calibration (Calibration) parameter

Various parameters need to be calibrated – they are explained in more
detail in the table. A detailed description of the calibration is given after the
table.
Menu item
Feed Cal.Main
FabricThickness Calibration of the material thickness detection
Man.St.Len.
Edge Guide
Pedal
130
Analog :
Digital :
FLPos: 0.0 Stroke:
Tens :
20
Explanation
Calibration of the stitch length and/or the feed
Calibration of the stitch adjustment lever
(optional equipment)
Calibration of the edge guide (optional equipment)  p. 132
Calibration of the pedal
Service Instructions 867-M PREMIUM - 03.0 - 05/2017
Programming
-2:328
278 -1: 175
0:
0 275
Max: 918
2.5
Pressu: 3
Speed : 0
Reference
 p. 131
 p. 132
 p. 132
 p. 133