Positioning The Arm Shaft - Dürkopp Adler 867-M PREMIUM Service Instructions Manual

5
Fig. 17: Positioning the arm shaft
(1) - Threaded pins
(2) - Machine casting
Proper setting
The 3 threaded pins (1) on the arm shaft crank (3) are seated completely
on the flat. The arm shaft crank (3) is flush with the machine casting (2).
To position the arm shaft:
1. Remove the arm cover (
2. Loosen the threaded pins (1) on the arm shaft crank (3).
3. Turn the arm shaft crank (3) such that the threaded pins (1) are seated
4. Push the arm shaft (3) to the right as far as it will go and flush with the
5. Tighten the threaded pins (1) on the arm shaft crank (3).
28

Positioning the arm shaft

WARNING
Risk of injury from moving parts!
Crushing possible.
Switch off the machine before you check and set
the position of the arm shaft crank.
completely on the flat of the arm shaft.
machine casting.
Positioning the arm shaft
③
①
(3) - Arm shaft crank

p. 17).
Service Instructions 867-M PREMIUM - 03.0 - 05/2017
②