Setting The Hook Lubrication - Dürkopp Adler 867-M PREMIUM Service Instructions Manual

21.2.2 Setting the hook lubrication

Fig. 115: Setting the hook lubrication
(1) - Hook
(2) - Blotting paper
The approved oil quantity for hook lubrication is a factory specification.
Hold a piece of blotting paper (2) next to the hook (1) while sewing.
Proper setting
After sewing a stretch of approx. 1 m, the blotting paper (2) will have been
sprayed with a thin and even film of oil.
To set the hook lubrication:
1. Open the throat plate slide ( p. 20)
2. Turn the screw (3):
Important
The released amount of oil does not change until the operating time has
run a few minutes. Sew for several minutes before you check the setting
again.
148
①
②
• Release more oil: turn counterclockwise
• Release less oil: turn clockwise
③
(3) - Screw
Service Instructions 867-M PREMIUM - 03.0 - 05/2017
Maintenance