Setting The Programs (Programs) Parameter; Setting The Electronic Handwheel (Jog-Dial) Parameter - Dürkopp Adler 867-M PREMIUM Service Instructions Manual

Programming

20.6.6 Setting the Programs (Programs) parameter

Various settings can be made for the programs.
The possibilities are explained in more detail in the table.
Menu item
Forward
Sound
Seg.Switch A switch between two seam sections is usually carried out with the
Abort

20.6.7 Setting the Electronic handwheel (Jog-Dial) parameter

The electronic handwheel can be activated or deactivated.
Service Instructions 867-M PREMIUM - 03.0 - 05/2017
Setting option
Sound when changing between two seam sections.
(Value range ON/OFF)
This function can also be assigned to Position -2 on the pedal.
(Value range ON/OFF)
Notice:
Position -2 actually causes a cancelation when actuated during a seam
section. If the section change function is assigned to Position -2, the soft-
key menu can be used for a cancelation (it is still possible to continue
sewing from that point; for a full cancelation of the program, press the
pedal in Position -2 again).
Mode Position
After the cancelation, the needle is merely brought to its
end position and the thread is cut (if activated).
Seg.End
Ending of the program with all configurations that are set
for this seam section.
Thread Trim
The thread cutter becomes active or remains inactive when a seam section
is canceled.
(Value range ON/OFF)
Pedal Abort
Abort a program by pressing the pedal in Position -2 twice.
(Value range ON/OFF)
►
button.
123